The Hydrostatic Pressure test evaluates a material’s resistance to water penetration. Products such as gowns, drapes and barrier fabrics are required by AAMI PB70 and EN 13795 to undergo this test. This test is also used for 510(k) submissions to the FDA. All testing meets the criteria set forth in AATCC 127, ISO 811, INDA IST 80.6 and AAMI PB70. Nelson Laboratories can perform all the required tests listed in AAMI PB70.
- AATCC 127
- AAMI PB70
- EN 13795
- ISO 811
- INDA 80.6
Standard turn around times (TAT) are listed below. Ask an expert for a specific consultation on your product.
|Code||Test||TAT (days)||Request Quote|
|HPT110||Hydrostatic Pressure Test||10||Add|
HPT110 - Hydrostatic Pressure Test
HPT110: 32 specimens recommended for FDA submission, Minimum of 5 specimens recommended. Each sample must be 8 x 8 inches (203 x 203 mm) minimum
Study OutlineThe Hydrostatic Pressure test specimen is clamped into the hydrostatic head tester (FX3000) and pressure is increased at a rate of 60 cm H2O per minute or 10 cm H2O per minute. The face side of the specimen is challenged directly with the water and the reverse side observed for fluid penetration. The hydrostatic pressure at which fluid penetration occurs in three areas of the specimen is recorded.
If testing to comply with the AAMI PB70, please note on sampling details as well as classification requirement.
If testing to comply with ISO 811, please note which rate of increase is needed (60 or 10).